Note
Wait 4-5 minutes between measurements.
When repeated measurements, because the arm appears congestion, it may not get correct blood pressure
measurement. After the blood flow, take a measurement once again.
When some factors affect the measurement results in measurement process, error messages hints will
appear on the screen, you can obviate the malfunction and restart a measurement.
In no physiological alarm state, press any button to carry on the corresponding button function; in audio
alarm state, press any button (except 【ON/OFF】 button) to clear up the audio alarm.
④Take off the cuff, hol d 【ON/OFF】 button to turn the monitor off.
*The monitor will automatically turn off after two minutes in which there is no operation to the device,
even if you forget to turn the power off.
Memory Function
The monitor is designed to store and display the blood pressure, pulse rate values and the date and time
when measured, which are up to 100 items. If there have been 100 items stored, when the 101
measurement have been taken, the earliest results are deleted.
Review The Memory Value
1.In the main interface (interface when boot-strap), press 【MEMORY】 button to review the most recent
measurement values in large-print with the serial number from 1 to 100.
2.Press 【UP】/【DOWN】 button to circularly switch the former measurement values.
*The right figure shows that there is no Measurement results.
To Next Page
Loading...
Need help?
General
