Significant concentrations of dysfunctional hemoglobin, such as carboxyhemoglobin and
methemoglobin.
SpO2 too low.
Bad circular injection of the part being measured.
It is required to use SPO2 probe which is provided by our company, contact with our sale department
when changes SPO2 probe.
Maintenance and Cleaning
Warning
Take cuff off the power source before cleaning the monitor or the SPO2 probe.
Caution
Do not subject the sensor to autoclaving.
Do not immerse the SPO2 probe into any liquid.
Do not use any SPO2 probe or cable that may be damaged or deteriorated.
Cleaning:
Use a cotton ball or a soft mull moistened with hospital-grade ethanol to wipe the surface of the SPO2
probe, and then dry it with a cloth. This cleaning method can also be applied to the luminotron and
receiving unit.
The cable can be cleaned with 3% hydrogen dioxide, 70% isopropanol, or other active reagent.
However, connector of the SPO2 probe shall not be subjected to such solution.
To Next Page
Loading...
Need help?
General
