8
To low the Spo2 and pulse rate limit, put the Dir to Down, press the button shortly to choose
the parameter to be adjusted, then press the button long time to low the value.
B. Adjust the alarm state
Press the button shortly to enter the Alarm item, then long press the button to choose alarm on or
off, press “ on” to open and “ off” to close the function.
C. Adjust the pulse rate alarm sound
Press the button shortly, move to “Pulse Sound” item, then long press the button to choose alarm
on or off, press “on” to open and “off” to close the function.
D. Exit the setting
Press the button shortly, move to “ EXIT”, then long press the button to exit the alarm sound and
alarm high and low limit adjust.
3) Wire data transmission adjust
Connect the USB cable with the computer, press the button shortly moving to item “USB”,
long press the button long press the button to choose whether send the data to the display
for synchronous show, if transfer, choose “on”, of end the transfer, choose “off”.
NOTE: Wireless and wire transmission could only use one mode, it is not available to
open the two function at same time.
4) Adjust the data store
This instrument has the 24 hour data store function, it can store the measured pulse rate
and SpO2 value accurately, transfer the data to the computer and show simultaneity.
Operation: press the button shortly and move to the “Record”, then long press the button to
enter the setting for start time of data store, as figure 6. Press the button shortly to move
the underline to the value to be set, then long press the button to start setting. After finish
the setting, move the underline to “Y”, press button long to quit the time setting menu,
records starts. If move the underline to “n”, press button long to quit the time setting menu,
records will not starts, the value stored last time will not be delete .If open the data store
function, the interface shut off after 30 seconds, and “ Recording” show on the screen, then
come black screen, if press the button shortly at this moment, there will show
“ Recording” on the screen, and long press can come to the Figure 5.After 24 hours
recording, “ Memory is full!” will show on the screen, tnen the device will power off
automatically.
NOTE: If open the store function, then the value stored last time will delete
automatically; when the sound and the store function open the same time, after black
screen, the pulse rate sound and the alarm will shut automatically to save power, and
the data transfer can work normally. After black screen, if the finger fall off, the
alarm works continuously, put the finger in again then the alarm stops.
To Next Page
Loading...
Need help?
General
