8. LED Indicators
User’s Manual
37
8.
LED Indicators
The POWER LED on the front face indicates each state of the
display as follows:
Table 8.1. LED Indicators
LED status Description
OFF The power supply off or the equipment not started normally
Green(ON) Normal operation
Green(Flashing) Power save mode
Orange(Flashing) Unsupported signal input *1
Orange(Flashing) No signal input *2
*1 The LED looks like this when the equipment cannot process the input signal to
provide normal display, for example, when the horizontal/vertical sync signal
frequency is exceeding the supported frequency.
See Chapter 10 "Display mode" for the display modes supported by this equipment.
*2 The LED looks like this also when the horizontal or vertical sync signal is turned off
by the power management function of the host computer. The equipment enters the
power save mode automatically when no signal has been input for about two seconds.
To Next Page
Loading...
Need help?
General
