Commander SK Getting Started Guide 33
Issue Number: 1 www.controltechniques.com
Safety
Information
Rating
Data
Mechanical
Installation
Electrical
Installation
Keypad and
Display
Parameters
Quick Start
Commissioning
Diagnostics Options
Parameter
List
UL Listing
Information
Indicates the last 4 trips of the drive.
The drive user program enable is used to start and stop the drive user program.
0: Stop the drive user program
1: Run the drive user program (trip drive if LogicStick is not fitted). Any out-of-range
parameter writes attempted will be limited to the maximum/minimum values valid for
that parameter before being written to.
2: Run the drive user program (trip drive if LogicStick is not fitted). Any out-of-range
parameter writes attempted will cause the drive to trip.
The drive user program status parameter indicates the actual state of the drive user
program.
-n: User program caused a drive trip due to an error condition while running rung n.
Note that the rung number is shown on the display as a negative number.
0: User program not fitted
1: User program is fitted but stopped
2: User program is fitted and running
Pr 61 to Pr 70 and Pr 71 to Pr 80 can be used to access and adjust advanced
parameters.
Example: It is desired that Pr 1.29 (Skip frequency 1) is to be adjusted. Set one of the
parameters Pr 71 to Pr 80 to 1.29, the value of Pr 1.29 will appear in the corresponding
parameter from Pr 61 to Pr 70. I.e. if Pr 71 is set to 1.29, Pr 61 will contain the value of
Pr 1.29 where it can be adjusted.
See Commander SK Advanced User Guide for advanced parameter details.
6.3 Parameter descriptions - Level 3
Set Pr 71 to Pr 80 to the required advanced parameter number to be accessed.
The value within these parameters will be displayed in Pr 61 to Pr 70. Pr 61 to Pr 70 can
then be adjusted to change the value within a parameter.
See Commander SK Advanced User Guide for further details.
No Function Range Defaults Type
55 Last trip
0RO
56
Trip before Pr
55
57
Trip before Pr
56
58
Trip before Pr
57
No Function Range Defaults Type
59 Drive user program enable 0 to 2 0 RW
No Function Range Defaults Type
60 Drive user program status -128 to +127 RO
No Function Range Defaults Type
61 to
Configurable parameter 1 to
configurable parameter 10
As source
70
Some parameters are only implemented if the drive is disabled, stopped or tripped and
the STOP/RESET key is pressed for 1s.
NOTE
No Function Range Defaults Type
71 to
Pr
61 to Pr 70 set up
0 to Pr 21.50
RW
80
To Next Page
Loading...
Need help?
General
