Need help?Do you have a question about the Control Techniques FXM5 and is the answer not in the manual?
General| Brand | Control Techniques |
|---|---|
| Model | FXM5 |
| Category | Inverter |
| Language | English |
Control via variable speed drive monitoring armature voltage for field weakening.
Control via Mentor II Drive for armature voltage and field current.
Setting field current at a fixed level using an internal potentiometer.
Provides guidance on mounting the FXM5 controller vertically with proper clearance.
Details recommended cable sizes, fuse ratings, and wiring practices for the FXM5.
Instructions for connecting the AC supply, including using an alternative AC supply.
Specifies how to make armature connections for different system control modes.
Recommendations for motor cable shielding and grounding to meet EMC requirements.
Details signal connections to terminal block TB1 for external field current control.
Procedure to set thyristor control mode (half or full control) using jumper LK3.
Procedure to set the maximum field current (Ifmax) based on turns and jumper settings.
Procedure for setting the armature-voltage range using jumper LK2.
Procedure for setting maximum and minimum field current levels.
How to set maximum field current using SET MAX FIELD potentiometer.
How to set minimum field current using SET MIN FIELD potentiometer and TEST switch.
Procedure to adjust armature voltage threshold for starting field weakening.
To Next Page