FXM5 User Guide
www.controltechniques.com Issue Number: 5
Declaration of Conformity
Control Techniques, The Gro, Newtown, Powys, UK. SY16 3BE
The AC variable speed drive product FXM5, current range 2A to 20A has been
designed and manufactured in accordance with the following European harmonised,
national and international standards:
This product complies with the Low Voltage Directive 73/23/EEC and the CE Marking
Directive 93/68/EEC.
W. Drury
Executive VP Technology
Date: 9 December 1996
This electronic drive product is intended to be used with an appropriate motor,
controller, electrical protection components and other equipment to form a
complete end product or system. It must only be installed by a professional
assembler who is familiar with requirements for safety and electromagnetic
compatibility ("EMC"). The assembler is responsible for ensuring that the end
product or system complies with all the relevant laws in the country where it is to
be used. Refer to the product manual or EMC data sheet for further information
on EMC standards complied with by the product, and guidelines for installation.
EN60249 Base materials for printed circuits
IEC326-1 Printed boards: general information for the specification writer
IEC326-5
Printed boards: specification for single- and double-sided printed boards
with plated-through holes
IEC326-6 Printed boards: specification for multilayer printed boards
IEC664-1
Insulation co-ordination for equipment within low-voltage systems:
principles, requirements and tests
EN60529 Degrees of protection provided by enclosures (IP code)
UL94 Flammability rating of plastic materials
To Next Page
Loading...
Need help?
General
