ControlTemp CT2001 - Wiring a Single Indoor Sensor; Wiring Multiple Sensors

CT2001 Touchscreen Programmable Thermostat
Fig. 28. Wiring a single Indoor Sensor.
47
Fig. 29. Wiring Multiple Sensors.
1 SENSORS MUST BE ARRANGED IN THIS CONFIGURATION TO
OPERATE CORRECTLY.
2 WIRES MUST HAVE A CABLE SEPARATE FROM THERMOSTAT
CABLE.
1. POWER SUPPLY. PROVIDE DISCONNECT MEANS AND
OVERLOAD PROTECTION AS REQUIRED.
2. IF MORE THAN ONE REMOTE SENSOR IS REQUIRED, REFER
TO FIGURE 29.
3. WIRES MUST HAVE A CABLE SEPARATE FROM THE
THERMOSTAT CABLE.
R
C
1
2
IRS-01
3
S1 S2 C R RC W W2 Y2 Y G
S1 S2 C R RC
IRS-01
1
2
S1 S2 C R RC
1
2
IRS-01
IRS-01IRS-01
IRS-01 IRS-01 IRS-01
IRS-01 IRS-01 IRS-01
IRS-01 IRS-01IRS-01