1 Introduction
Ethernet Option Board /
700.002 735 AE01
1-1
1 Introduction
Converteam LV7000 frequency converters can be connected to Ethernet using an Ethernet fieldbus board
OPT-CI.
The OPT-CI can be installed in the card slots D or E.
Every appliance connected to an Ethernet network has two identifiers; a MAC address and an IP address. The
MAC address (Address format: xx:xx:xx:xx:xx:xx ) is unique to the appliance and cannot be changed. The
Ethernet board's MAC address can be found on the sticker attached to the board or by using the Converteam
IP tool software NCIP Config.
In a local network, the user can define IP addresses as long as all units connected to the network are given
the same network portion of the address. For more information about IP addresses, contact your Network
Administrator. Overlapping IP addresses cause conflicts between appliances. For more information about
setting IP addresses, see Section 3, Installation.
Internal components and circuit boards are at high potential when the frequency
converter is connected to the power source. This voltage is extremely dangerous and
may cause death or severe injury if you come into contact with it.
To Next Page
Loading...