Service Handbook OEB/OES/OGB/OGS
Safety Advice
Improper positioning, installation, setting, training, service or maintenance, as well as changes
on the unit can cause injuries that could lead to death of the installer or operator and also lead
to damage on the unit.
Please note that any improper performance regarding the above, invalidates the guarantee.
Before looking for an error or performing maintenance or repair work on the unit, thoroughly and
carefully read through the Safety Advice and the appropriate Service Instructions. Observe also
the relevant Safety Advice in the Installation Handbook and the User Manual. Both are included
in the unit shipment. Check with your Customers.
Hazardous
Attention - Danger of explosion when gas odor is present
Immediately shut off the gas supply
Ventilate the room thoroughly
Avoid sparks (this means the operation of switches, telephones or contact with
electric switching elements ) or open flames.
Inform the gas supplier and/or the fire department (external telephone).
Attention - Electric shock
The combination oven steamer main power supply must be shut off before
opening the side panel and performing maintenance or repair work (only by a
certified electrician) !
An all-pole isolation switch with a minimum contact opening of 3mm must be
located close to the unit - on site in order to switch off the power supply when
outer cleaning is performed, repair or installation work is done and during
longer times that the unit is out of operation.
Danger of injury
Attention - Danger of scalding or burning:
Maintenance and repair work should only be performed on a cold unit!
Never spray into a hot oven with the hand shower!
Allow combination oven steamer to cool down to an oven temperature under
60°C.
General Advice
Observe all prevailing regulations and standards.
Only use original spare parts.
AS/11-2011 0_04e_Safety Advice_b
Page 1 / 2
To Next Page
Loading...
Need help?
General
