Service manual OEB/OES/OGB/OGS
5_00e Troubleshooting list_L 8/27 2013-01-30
E
T
O
E
B
O
E
S
O
G
B
O
G
S
Error-
message
Error description possible cause or remedy
measured. Normally it
takes about 12 sec.
per rotation (just Mini).
E21.0
ID5
Oven sensor (B6-
thermoelement)
interruption
Sensor wiring interrupted (plug X16 of the control
module)
Oven sensor (B6) interrupted (defective)
ID14
Oven sensor B6 (in
front of the fan) – short
to frame. ATTENTION:
The short to frame
cannot be clearly
detected. It may be a
different thermocouple
probe.
Thermoelement probe (B6) or other has contact with
appliance housing.
Thermoelement (B6) or other is defect
E22.xxx Core temperature
sensor
(B10- thermoelement)
interruption (if more
than 2 measuring
points are interrupted).
If a 1-point probe is
selected, an error will
be issued
immediately.
Sensor wiring interrupted (plug X16 of the control
module)
CTS sensor (B10) interrupted (defective)
E22.1
ID6
Core temperature
sensor1 sensors break
(B10-thermoelement)
interruption.
If a 1-point probe is
selected, an error will
be issued
immediately.
Sensor wiring interrupted (plug X16 of the control
module)
CTS sensor (B10) interrupted (more than 2
thermoelements are defect)
E22.2
ID7
Core temperature
sensor2 sensor break
(B10-thermoelement)
interruption.
If a 1-point probe is
selected, an error will
be issued
immediately.
Sensor wiring interrupted (plug X16 of the control
module)
CTS sensor (B10) interrupted (more than 2
thermoelements are defect)
E22.3
ID8
Core temperature
sensor3 sensor break
(B10-thermoelement)
interruption.
If a 1-point probe is
selected, an error will
be issued
immediately.
Sensor wiring interrupted (plug X16 of the control
module)
CTS sensor (B10) interrupted (more than 2
thermoelements are defect)
To Next Page
Loading...
Need help?
General
