Service manual OEB/OES/OGB/OGS
AS/11-2011 6_03e_Update of Software EasyTouch-control_b.doc
Page 2 / 5
Instructions:
5. Please wait until the update process is completely finished. While this is taking
place the grey bar (see red arrow in Screenshot 2) completely fills up to 2
times!
6. Then remove the USB stick and click on “Exit” (see Screenshot 3).
7. If the combi steamer starts as usual in the operating mode, perform another
update of the control module (see point 6.3.3).
8. If the following screen appears (see screenshot 4) repeat steps 2 to 7.
Screenshot 4
Screenshot 2
Screenshot 3
To Next Page
Loading...
Need help?
General
