Service Handbook OEB/OES/OGB/OGS
AS/11-2011 / Item 7016574 6_12e_Door latch_Door contact switch removal and installation_b.doc
Page 2 / 2
Door contact switch (Reed contact) replacement
Instructions – Removing the door catch and the reed:
Mark the position of the door catch 1 on the front plate.
Remove the screws M6 with the hexagon socket 2 in the door catch 1.
Carefully pull the door catch 1 out of the opening.
Remove the flat head screw M3x16 5 on the reed contact switch 3.
Disconnect the connection wires fronm the reed contact switch 3 on the crimp
place and pull out the complete switch from the unit.
Carefully pinch off the cable binder 6 on the end of the fiber glass hose 4 and
pull off the fiber glass hose from the old reed contact.
Instructions – Reed contact switch and door catch installation:
Slide the fiber glass hose 4 onto the connection wires of the new reed contact
3 and thread the connection wires into the unit.
Wire and crimp the new reed contact switch 3 on the connection wires that go
to the controls.
Slide the fiber glass hose 4 onto the reed contact switch 3 and fasten with a
cable binder 6 (pull on to maximum).
Assemble the new reed contact switch 3 with the flat head screw M3x16 5 on
the old position on the door catch see dimensions 30,5 +/-1 mm. You can
use the old reed contact switch as a comparison sample.
Place the door catch 1 in the front opening and screw lightly into the marked
position on the plate.
To adjust the door catch, proceed as follows:
Close door and set door latch vertically until the locking worm can be heard
to catch.
Hold door catch in this position
Open door latch again.
Tighten the fasting screw of the door catch.
1 = Door catch
2 = Hexagon socket screw
3 = Reed contact switch
4 = Fiber glass hose
5 = Flat head screw M3x16
6 = Cable binder
To Next Page
Loading...
Need help?
General
