www.cool-icam.com
© 2001 TCG. UK Version 1 0301
Page 15
8. Getting Started
8.2 Switching the Cool-iCam Plus On from the Stand-by Mode
8.3 Taking an Image
Press the Shutter Button to take an image. The Cool-iCam Plus will beep. A high pitched beep
indicates that the image was taken successfully and the counter will count down. The LCD screen
displays the number of available images remaining.
A low beep indicates insufficient light to take an image.
A series of beeps indicates that the Cool-iCam Plus is full, the LCD will display and the Memory
indicator will be empty.
•
•
8.1 Switching the Cool-iCam Plus On
Slide the Power Button from (OFF) to (ON) to turn on your Cool-iCam Plus. The LCD will
initially indicate and NORM for Normal Resolution mode and it will also display the number of images
which may be taken.
Important Notes:
The OFF position ( ) of the ON/OFF Switch is designed to protect the life of your batteries, however, all the stored images will be lost when the battery
is removed or ON/OFF Switch is turned to the “OFF” position and there is no power via the USB cable.
Pressing the Mode Button when the Cool-iCam Plus is in Stand-by Mode (ON/OFF Switch is set to "ON"
and LCD is blank) will reactivate your Cool-iCam Plus.
By pressing the Mode Button you can cycle through additional features as displayed on the LCD. When a
given mode is displayed it can be accessed by pressing the Shutter Button. If an option is not confirmed
within 5 seconds the display will revert to show the number of available images that can be taken.
8.4 Audio Recording Mode
To create an audio clip:
Press the Mode Button until the appears on the LCD.
Press and hold down the Shutter Button within 5 seconds to start
recording. A "beep" means recording is started. Release the Shutter
Button to stop recording. You can record an audio clip up to 12 minutes
long. If the Shutter Button is not pressed within 5 seconds the Cool-
iCam Plus will revert to the normal image taking mode.
1.
2.
To Next Page
Loading...
