Cooler Master GP2711 - Updating the Monitor Firmware

16
Updating the Monitor Firmware
1. While the monitor is turned on, disconnect the power cable and all input sources from
the monitor.
2. Copy the GP2711.bin firmware file onto a USB flash drive’s root directory.
3. With the power cable still unplugged from the monitor, insert the USB flash drive into the
USB-A port located next to the DC IN port.
4. Reconnect the power cable to the monitor to begin automatic updating of the firmware.
5. The monitor will reboot after a "success" message has been displayed. The rebooting
process will take two minutes and will not display any progress status, DO NOT
disconnect the power cable from the monitor during this time.
6. When the monitor enters factory setting mode (displaying alternating flashes of different
colors), check the moving information window on the display to confirm that the updated
firmware version is correct, then press the power button (DC off), press it again (DC on)
to revert to the normal display image, and remove the USB flash drive from the monitor.
NOTE:
The USB flash drive must be in FAT32 format in order to successfully update the
monitor’s firmware.