3. Testing Commands
Page 72 497096, Issue 6
Keypad Display Printed (9853 only)* Meaning
Low Batt Rstr Low battery Restore Low battery detected on control unit
Low Batt Rstr Z== Low Batt Rstr Zone Z== Low battery reset on control unit
Md K== Alarm K/P Medi K== Medical alarm started at keypad ==
Override # Override # Fault overridden in level/partition #
PA K== Alarm K/P PA K== Panic alarm started at keypad ==
PA Z== Alarm Panic Alarm Z== Panic alarm started in zone ==
PA Z== Rstr Panic Restore Z== Panic alarm reset in zone ==
RF Jamming Jamming Start Radio jamming detected
RF Jamming Rstr Jamming End Radio jamming reset
RF Sup Fail Z== Supervision Fail Z== Radio supervision failure detected in zone
==
RF Sup Rstr Z== Super'ion Restore Z== Radio supervision failure in zone == reset
Set Fail Z== U== Exit Timeout Z== System failed to set because of fault in
zone ==
Smk Det Alm Z== Smoke Det. Alarm Z== Smoke detector alarm in zone ==
Smk Det Res Z== Smoke Det. restore Z== Smoke detector alarm reset zone ==
Soak Fail Z== Test Zone Fail Z== Soak test failed in zone ==
System Rearmed Rearmed System rearmed after an alarm
System Startup Startup Power applied to system
System Tamp Rst System Tamp Restore System tamper reset
System Tamper System Tamp System tamper
Tamper F== Rstr Forbi Tamp Restore F== Forbikobler keypad == tamper reset
Tamper K== Rstr Tamper K/P Restore K== Keypad == tamper reset
Tamper Z== Tamper Z== Zone == tampered with
Tamper Z== Tamper In Day Z== Tamper in zone == during the day
Tamper Z== Rstr Tamp Restore Z== Zone == tamper reset
Tech Z== Alarm TA Z== Technical alarm in zone ==
Tech Z== Rstr TA Restore Z== Technical alarm in zone == reset
Tel Line Fault Tel Line Fault Fault on telephone line (e.g. line cut)
Tel Line Rstr Tel Line Restore Line fault reset on telephone line
Telecmd Low Bat Telecomm Low Battery Low battery in 723r telecommand
Telecmmd PA Telecmd Panic Panic alarm from 723r telecommand
Test Call Man Trig Test Test call made
Test Call Periodic Test Test call at a specified interval
U== # Set U== Armed L= User == set level/partition #
U== # UnSet U== Disarm L= User == unset level/partition #
U== Change U== U== Changed U== User == changed access code for user
==
U== Delete U== U== Deleted U== User == deleted access code for user ==
U== Dload Fail U== Download FAIL Download by user == failed
U== Duress U== Duress Duress code entered by user ==
U== Off-Site U== Prog. Mode End Installer exited from programming mode
U== On-Site U== Prog. Mode Installer entered from programming mode
U== Ptn # Reset U== Reset # User – reset partition #
To Next Page
Loading...
Need help?
General
