Cooper WaveLinx Wired - Accessing the Operation Menu; Menu Navigation; Overriding Channels

Menu Navigation
Within the control panel menu system, use the following
buttons to navigate:
Press to select an item or to save
changes.
ENT
Press to enter an option or select an item.
ESC
Press to escape from an option and return to the
previous level.
The Asterisk will be used on some Scenes to
perform special functions.
The menu system is comprised of two main sections:
The Operation menu
Contains functions for users to operate the system.
Functions include: Output override, Timeclock functions,
Power data figures, etc.
The Conguration menu
Provides functions primarily used during initial
commissioning and subsequent fine tuning of the
installation by engineers.
To prevent unauthorized access, use the Password Manager
to configure four-digit passwords for the Operation and
Configuration menus.
Operation Menu Layout
Help
OutputOverride
TimeclockManager
PowerData
OperationMenu
Accessing the Menus
During normal operation, the control panel screen shows
only the time, date and device number
ð
Cooper Controls
21:56
August 14, 2008
Device 255-129
To Access the Menus
1. Press the
ENT
button to display the Select Access Level
menu
ð
.
2. Use the
or buttons to highlight the required
menu (Operation or Configuration) and then press the
ENT
button to select.
Select Access Level
Operation
Configuration
Contact Cooper
3. If requested, enter the four-digit password and press the
ENT
button.
ote: N When the unit is supplied, there are initially no
passwords - see the section ‘Configuring passwords’.
4. If the password is accepted, the chosen menu will be
displayed.
Configuration Menu Layout
ConfigurationMenu
Configure Outputs
Wallstation Wizard
Scene Edit
EmergencyScene Edit
Help
Operation
Output Override
Total Power
Time & Date
Coordinates
Daylight Saving
Timestamp Frequency
Enable/Disable
Events
Display by Phase
Display by Output
iCANnet OFF/ON
All Outputs
Ethernet OFF/ON
Each Output
DMX OFF/ON
Select Scene
RS-485 OFF/ON
Contact Inputs OFF/ON
Timeclock Manager
Power Data
Communications
Wallstation Wizard
Conguration
Emergency Scene
Edit
Scene Edit
Congure Output Output X
Input 1
IP Addr
IP Mask
Gateway
MAC
Output Mapping
Restore Defaults
Restore Defaults
Air-Gap Mode
Input 2
iCAN Always
All Outputs
Scene
Standard Type
Min/Max
Power Curve
Relay Zero Cross
Operation at Min
Set Area/Zone
Stabilization
HF Curve
Air-Gap Isolation
Setup Action
DMX Always
Output x xx%
DMX When Present
Password Manager
Contact Inputs
Ethernet Settings
DMX Options
Control Hierarchy
Universal Source Controller - Feed Thru WaveLinx Wired
9850-000234-02 page 15
May 2024
www.cooperlighting.com