Need help?Do you have a question about the Copeland C Series and is the answer not in the manual?
General| Brand | Copeland |
|---|---|
| Model | C Series |
| Category | Measuring Instruments |
| Language | English |
Details of the technical specifications for the semiconductor, electrochemical, and infrared versions.
Details on the physical dimensions and weight of the device.
General considerations for successful installation of the gas detection system.
Practical advice and guidelines for optimal installation of the gas detectors.
Recommended mounting height for different gas types.
Guidance on positioning detectors in equipment rooms.
Recommendations for installing detectors in cold rooms.
Tips for installing detectors on chillers.
Installation advice for AC systems like VRF/VRV.
Step-by-step instructions for mounting and wiring the device.
Describes the start-up and warm-up phases of the device.
Explains the visual indications (LEDs, relays) of device status.
Instructions for configuring the device using the rotary switch.
Details on the configurable analog output signal and its relation to gas concentration.
Configuration and behavior of warning and alarm thresholds and relays.
Using the magnet for Bluetooth activation and alarm/warning acknowledgement.
How to activate and deactivate Bluetooth mode using the magnetic key.
Acknowledging active alarms and warnings using the magnetic key.
Overview of the mobile application's capabilities for device management.
Steps to connect the CRLDS device to the mobile application via Bluetooth.
Guidelines for setting up and connecting the device to a Modbus RS485 network.
Detailed list and description of Modbus registers and their meanings.
Procedure for periodic calibration of the sensor using a calibration kit.
Description of the calibration kit components and usage.
Step-by-step guide for calibrating the device using the Copeland CRLDS mobile application.
Instructions for performing calibration using Modbus communication.
Details on using Modbus registers for calibration commands and status.
Procedure for replacing the sensor module on built-in and remote versions.
Guidelines for cleaning the gas detector safely and effectively.
Explanation of how semiconductor and electrochemical sensors work.
Details on the working principle of semiconductor (MOS) gas sensors.
Explanation of the electrochemical sensing mechanism.
Information about pre-calibrated sensors and their certificates.
List of gases detected, their groups, and corresponding sensor module and register values.
Instructions for proper disposal of the device and its sensors.
Guidelines for disposing of the device as EEE.
Safety precautions for disposing of the device's sensors.
List of standards and directives the device complies with.
List of part numbers for different CRLDS models and accessories.
To Next Page
