Coredy CX-E120 - WPS - Method

02
WPS - Method:
You can also use the WPS function as an alternative Set-up
method, if you have a WPS button available on your primary
router.
Hold the WPS button of your Primary Router/WiFi AP till the
WPS LED starts blinking.
Press and hold the WPS 3 seconds on the Rear Panel.
Once WPS light starts blinking on it as well, please wait for a
minute for The primary router/AP and the Extender Coredy
CX-E120 to pair up and then connect to the "Coredy
CX-E120_2.4G _EXT or Coredy CX-E120_5G _EXT" SSID
in your Smart Phone using your primary router's WIFI
password.
Password/WIFI Key/Security key column and click on
"Apply"
7.
In the next window, you'll see the reboot process with a
Bar. When the Bar reaches 100%, (Leave the device for
1 minute to let it reboot itself).
8.
Open the list of available networks again using your
smartphone. Find out the New SSID "Coredy
CX-E120_2.4G _EXT or Coredy CX-E120_5G _EXT"
and connect with it using the same password as of your
primary router/AP.
9.
If the internet works, unplug Coredy CX-E120 and plug
it halfway between your Router and the Device intended
for the internet usage/dead zones in your home where
you were getting low to no WIFI signals.