Use and maintenance manual – 10/2016 Rev. 3 Page 2
Machine dimensions
Figure F1.1
1. INTRODUCTION
This manual is an integral part of the machine and it must to stay with wheel balancer until the scrapping of the machine.
Read carefully each section of this manual before using the machine. The manufacturer is not responsible for damage and/or injury
caused by failure to follow the instructions of this manual.
We also recommend:
• Keep the manual near wheel balancer for easy access;
• Keep the manual in a place protected from dirt;
• Do not damage the manual.
In the manual the following symbols are represented:
Indicates operations that require special attention
Indicates prohibitions
Indicates possible danger for the operator
Cormach s.r.l. We reserve the right to make any change to products in order to improve them.
Cormach s.r.l. We reserve the right to make any change to this manual without notice.
2. INTENDED USE
This manual is an integral part of product.
Read carefully warnings and instructions contained in this manual because they provide important information about SAFE USE and
MAINTENANCE.
KEEP WITH CARE THIS MANUAL NEAR THE MACHINE TO FACILITATE ANY CONSULTATION BY OPERATORS.
The wheel balancers of the range MEC are designed for balancing wheels for motorcycles (MOTO). The machines can work on wheels
with diameter from 1" to 35" (or from 25 to 890 mm) and width from 2" to 20" (or from 50 to 500 mm).
All functions and controls are set through a series of buttons arranged on a panel. The data are displayed on a led display.
To Next Page
Loading...
