Cormach MOTO MEC - 15 Use of the Machine in Normal Mode Pag

Use and maintenance manual – 10/2016 Rev. 3 Page 17
120
Rotate manually the motorcycle flange so that the
wheel will turn counterclockwise.
130 At the end of the spin, the MOTO wheel type calibration is
finished and the machine will switch to NORMAL mode, ready
to run the balancing.
How to exit the MOTO wheel type calibration of the machine
At any time it is always possible to exit the calibration procedure during its progress by pressing [F+P3] . The
machine will return to SERVICE mode displaying the SER SER writing. To return to NORMAL mode, press the [F+P3] key again [F+P3]
. The calibration in progress will be cancelled and the machine will use the values of MOTO wheel type
calibration which were previously stored. Also in this case the MOTO wheel type and the ALU1 Program Type will remain set. The
wheel dimensions will be those which were automatically set by the machine for this kind of calibration.
15. USE OF THE MACHINE IN NORMAL MODE
Display for the machine controls
To use the machine, you must select or set as follows:
• Tipo di Programma (programma per ruote MOTO o QUAD). Programs for wheels MOTO ALU1;
• Tipo di Ruota (MOTO, QUAD). Default = MOTO;
• Dimensions of the wheel to balance. Sizes must always be entered manually;
• Dynamic or Static balancing. Default = Dynamic;
• Display resolution X1 or X5. Default = X5.
The selections described above can be entered before or after the spin. For any variation of the selection or data settings, the machine
will run a calculation by displaying the new values of imbalance.
After making the desired selections/settings
it is possible to rotate manually the motorcycle flange so that the wheel
will turn counterclockwise. During the launch the machine displays the correct speed of launch (Figure 15.1).
Figure F15.1: Correct speed of launch
At the end of the spin, the machine displays the wheel imbalance values.
Apply the weights displayed by the machine at the indicated positions and then run a second test spin. Normally the weights are
applied at 12 o’clock.