Cornelius Energize 2 - 11 Problems and Troubleshooting

C Energize proizvodna serija
34
11. Problems and Troubleshooting
Before looking for problems with the dispensing equipment, first check:
Is the electricity to the device interrupted?
Is the flow of water to the device interrupted?
Are the beverage containers empty?
Is the CO
2
-cylinder empty?
Type of problem Cause Remedy
Beverage too warm compressor is
running
Condenser dirty Use brush to clean condenser louvers
Beverage too warm, compressor not
running
Compressor defective
Electric control defective
Call service technician
Check whether the carbonator
motor is running; if
not, call service technician
Beverage foams at a tap Syrup stored too long Connect with fresh product
Beverage foams at all taps
CO
2
-pressure too high
All syrups enriched with CO
2
All beverages stored too warm
Too much beverage being dispensed
Set CO
2
pressure
Connect container with fresh product
Check storage temp
Note out-put capacity
CO
2
-volume in the beverage is too
low
Air in carbonator
Beverage dispense rate at capacity
CO
2
-cylinder empty
Valve on CO
2
-cylinder is closed
Valve on pressure regulator is closed
CO
2
-pressure too low
Water temperature to high
Bleed air
Reduce dispense rate
Change CO
2
cylinder
Open CO
2
valve
Open valve
Adjust valve to pressure
Ice bank used up, allow time to build
new ice bank
Too much or not enough syrup in
the beverage
Regulator in tap is blocked
Tap is misaligned
Pressure for syrup too low or to high
Call service technician
Call service technician
Adjust CO
2
-pressure
Tap just outputs concentrate Note!
Only with mechanical taps
Carbonator pump is not running
Check if water feed line is open
Check if water flow pressure of 2 bar
Check if Carbonator pump is running,
if not call service technician