Standard Recommended Procedure 003-794-AEN | Issue 14 | March 2020 | Page 10 of 27
4.5 Install Trunk Cables from Rear of Housing
If rear cable entry into the housing is desired or necessary, the backplates must be turned 180 degrees before
installing the cables.
Step 1: Remove existing backplates by removing the four screws (Figure 15).
Step 2: Turn the backplate 90 degrees as shown and reinstall the four screws.
Step 3: Insert cradle feet into backplate as shown in Figure 13 or Figure 14 for your cradle type.
Figure 15 — Reorient Backplate
To Next Page
Loading...
