Standard Recommended Procedure 003-794-AEN | Issue 14 | March 2020 | Page 9 of 27
Step 3: Open rear housing door. Route cables into housing through side openings.
Step 4: Insert cradle feet into backplate and slide into slots to lock in place.
Step 5: Repeat for all trunk cables and allow connectorized MTP legs to ow out the rear of the housing until
ready to mate in the appropriate module or panel.
4.4.2 Installing Trunk Cable with Keyhole Adapter
Step 1: Orient keyhole adapter to where leg side of trunk is near keyhole adapter release tabs (Figure 14).
Step 2: Align groove on furcation body with ridge in keyhole adapter.
Step 3: Once the groove is aligned, slide down and back until furcation body is completely mounted on the
keyhole adapter.
Step 4: Align keyhole adapter with mounting plate. Push down and slide keyhole adapter back until it locks
into place.
Figure 14 – Install Trunk Cable with Keyhole Adapter
Figure 13 — Install Trunk Cables with Keyhole Cradle
To Next Page
Loading...
