Standard Recommended Procedure 003-794-AEN | Issue 14 | March 2020 | Page 26 of 27
6.3 Remove Trunk Cable
6.3.1 Cable in Keyhole Cradle
If necessary to replace trunk cable or keyhole cradle, remove per the directions in this section (Figure 33). Install
new cable or cradle per the directions in Section 4.4.
Step 1: Pull back on both latches while pushing cradle in opposite direction. Lift cradle and cable up.
Step 2: Open cradle door.
Step 3: Lift furcation plug out of the cradle.
Figure 33 —Remove Trunk Cable in Keyhole Cradle
6.4 Changing the Polarity of an LC Uniboot Connector
In some applications, it may be desirable to reverse the polarity of the LC Uniboot Connector. To do so:
Figure 34 — Reverse Polarity of the LC Uniboot connector
To Next Page
Loading...
