corob D600 extra - Shipping, Handling and Unpacking; General Handling Warnings; Installation Site Environment

SHIPPING, HANDLING AND UNPACKING - 15
COROB™ D600 - D700 - D800 EXTRA
4 SHIPPING, HANDLING AND UNPACKING
4.1 General warnings
DANGER
To avoid personal injuries and property damage, use the utmost care and caution when handling the machine,
and carefully follow the instructions given in this chapter.
Do not insert the forks of the lift truck into the long side to lift the packing.
The packing must be handled only by skilled personnel using appropriate handling equipment.
7261112675
FRONT SIDE
7261112675
7261112674
7261112674
Figure 4
4.2 Environment conditions of the installation site
Environment requirements for the site where the machine is to be used:
• Clean and dust-free.
• With level and stable oor.
• Fitted with a grounded power supply socket.
• Equipped with sufcient lighting to ensure good visibility from every point of the machine.
• Ventilated to prevent the concentration of harmful fumes.
• Temperature between 10 °C (50 °F) and 40 °C (104 °F) and relative humidity between 5% and 85%,
without condensation.
WARNING
The environment working conditions are strictly related to the type of colorants used (ask for information
from the paint manufacturer). The requirements indicated above are valid for the machine only.
Do not place the machine near heat sources or in direct sunlight. Also humidity sources should be avoided.
The machine must be used indoors only.
Environment conditions outside the values indicated (chapter 8.1) may cause serious damage to the machine,
especially the electronic equipment.