corob D600 extra - Using the Dispenser; General Usage Warnings; Daily Start-Up Procedures

USING THE DISPENSER - 27
COROB™ D600 - D700 - D800 EXTRA
6 USING THE DISPENSER
6.1 General warnings
DANGER
The machine must be used by a single operator.
It is strictly forbidden to bypass and disable the safety devices and protections.
Do not, for any reason, place your hands in the dispensing area when running the machine, except for loading
and unloading the cans.
The panels must be kept closed at all times.
6.2 At the beginning of the working day
At the beginning of each work shift, always carry out the following operations:
• Check that the nozzle center is clean.
• (With humidier system for solvent-based colorants or without humidier system) Check that the sponge
is clean and saturated; if it is necessary to saturate, use only appropriate liquid (the choice of the liquid
depends on the nature of the colorants, and must be done directly by the manufacturer of the products
used).
• (With humidier system for water-based colorants) Check that the water in the bottle is not below the
minimum level.
• Carry out system Initialization and Purge.
6.3 Running the machine
The operator is guided in running the machine by the COROB™ management software, which displays the
instructions to be carried out and the actions performed by the machine.
Steps Options Reference
Make the selections from the management software
(selection of the product, formula and cansize).
Load the can in the machine and adjust the height of the can
shelf.
with semiautomatic
shelf
chapter 6.3.1
with automatic shelf chapter 6.3.2
with panel roll
conveyor
chapter 6.3.3
Adjust can position with respect to the dispensing center.
with can centering
device
chapter 6.3.4
with Laser B.H.L. chapter 6.3.5
Carry out punching of the can lid (optional). with punching device chapter 6.3.6
Via the software, enter the formula dispensing command. chapter 6.3.7
When dispensing is nished, remove the can and proceed
with another dispensing process.