SHIPPING, HANDLING AND UNPACKING - 17
COROB™ D600 - D700 - D800 EXTRA
7. Completely unscrew and remove all screws and nuts fastening each bracket C to the pallet.
8. Raise the feet (chapter 4.3.1) until when the machine can move easily on its wheels.
9. Lower both platforms.
10. Grasp the machine on the sides (this must be done by at least two people) then slide it slowly along the
platforms on its wheels, then lower it to the ground.
4 6
7
9 10
A
B
C
Figure 6
11. Lower the feet (chapter 4.3.1) to support and level the machine properly, and make sure that the wheels
are not resting.
To Next Page
Loading...
