Cortalk RMU1 - Detailed Status and Cap Detect Calibration

MOBILTEX® DATA LTD.
Calgary, Alberta
www.corTalk.com
TITLE: RMU1 Installation and Configuration Guide
DOCUMENT NO.:
RMU1-MAN-001
SHEET:
40 of 53
REV:
1.14
Figure 41 Detailed Status Dialog
6.3.1.10 Cap Detect Calibration
The RMU1 is equipped with a non-contact sensor (see Figure 43) that can detect when a test station cap is installed over
the RMU1. This sensor may require calibration to operate correctly. In the event that a cap is not detected properly,
click the ‘Cap Detect Calibration’ button. The following dialog will pop up.
Figure 42 Cap Detect Sensor Calibration Dialog