MOBILTEX® DATA LTD.
Calgary, Alberta
www.corTalk.com
TITLE: RMU1 Installation and Configuration Guide
DOCUMENT NO.:
RMU1-MAN-001
Banana jack test point kit.
Replaces standard test point termination screws to provide banana
jack functionality. Kit contains 5 replacement screws, washers and
nuts.
Mobiltex Part Number A20100RMU10
Test station with banana jack test points and shield.
Kit consists of an orange test station (A20A03RMU10), 5 installed
banana jack test point screws (A20100RMU10), and a drilled test
station shield (A20100RMU11). The components are factory installed
in the configuration shown. Alternative custom configurations are
available for purchases of 100+ units.
Mobiltex Part Number A20A03RMU14
Test station with RMU1-to-test-station flex PCB
Connects the RMU1 6-pin connector directly to the test station bolts.
Mobiltex P/N A03A00RMU01 (Orange with 8 bolts)
Mobiltex P/N A03A00RMU02 (Orange with 5 banana jack bolts)
Separate AC/DC Coupon Board For Test Station With Flex PCB
10 Ohm shunt and link PCB allowing use of separate AC/DC coupons
with test station flex PCB.
Mobiltex P/N A20A0333401
Table 4 RMU1 Accessories
To Next Page
Loading...
