63
Boot Configuration
Setup Prompt Timeout Select number of seconds for Setup from 1 to 65535
Bootup NumLock State
NUM-LOCK on boot: On or Off
Quiet Boot
Enable or Disable
Fast Boot
Enable or Disable
Skip VGA
Enable or Disable
Skip USB
Enable or Disable
Skip PS2
Enable or Disable
CSM16 Module Version 07.68
GateA20 Active
Upon Request or Always
Option ROM Messages
Force BIOS or Keep Current
Interrupt 19 Capture
Disabled or Enabled. Allows Option ROMs to trap Interrupt 19
Boot Option Priorities
Boot Option #1 Select first boot device
Boot Option #2 Select second boot device
CD/DVD Drive BBS
Priorities
If you have more than one CD/DVD, select the primary
Hard Drive BBS Priorities If you have more than one HDD, select the primary
Security Setup
CMOS Password Support
Two Levels of Password Protection
CMOS set-up provides both a Supervisor and a User password. If you use both passwords, the
Supervisor password must be set first. The system can be configured so that all users must enter a
password every time the system boots or when CMOS Setup is executed. The Supervisor and User
passwords activate two different levels of password security. If you select password support, you are
prompted for a three to twenty character password. Type the password on the keyboard. The
password does not appear on the screen when typed. Make sure you write it down. If you forget it,
you must drain NVRAM and reconfigure.
To Next Page
Loading...