38
PLACEMENT AND LEVELING RANGE
IMPORTANT:
• Do not lift by the oven door handle or control knobs. Push, pull, or lift only
on the body or structural areas, such as oven, oven face, or back corners
of range.
• Do not move unit by pushing or pulling on the door or control panel.
Grasp the left/right door area to push the unit.
• Move range by lifting, not sliding, to prevent damage to floors.
• Use a belt when moving the range to prevent damaging the floor, or use
cardboard, plywood, or stiff plastic to protect floors if sliding is necessary.
• Be careful not to pinch or kink the gas or electrical connections. If unit
does not move in smoothly, check for obstructions. Do not attempt to
force the unit into position.
Getting the unit properly placed in the installation space and level may
require multiple attempts. It is recommended to measure and adjust leveling
legs carefully before placing into the installation space, as the leveling legs
may be difficult to adjust once the range is in its final position.
WARNING
EXCESSIVE WEIGHT HAZARD
CAUTION
LACERATION, FOREIGN OBJECT, CRUSH HAZARD
• Use two or more people to move and install range. Failure to do so can
result in back or other injury.
• When installing, moving, or servicing any appliance, wear proper
protective equipment, including cut resistant gloves, steel-toed shoes,
and safety glasses.
To Next Page
Loading...
Need help?
General
