47
Low flame High flame
ADJUST FLAME HEIGHT
Adjust the height of surface burner flames. The cooktop "low" burner flame
should be a steady blue flame approximately 1/4" (6 mm) high. Propane gas
flames have a slightly yellow tip.
To Adjust Standard Burner:
The flame can be adjusted using the adjustment screw next to the valve stem.
The valve stem is located directly underneath the control knob.
NOTE:
IMPORTANT: Adjustments must be made with all other burners in operation
on the highest setting. This prevents the flames from being set too low,
resulting in the flame being extinguished when other burners are turned on.
1. Light all burners and turn to the highest setting.
2. Turn the knob on the burner being adjusted to the lowest setting.
3. Pull straight out and remove the control knob.
• If the adjustment screw is covered by cushioning, gently push
cushioning to the side to unveil the adjustment screw in the lower
right of the control knob stem.
A
B
Valve Stem
Adjustment Screw
A
B
To Next Page
Loading...
