58
• 3/8" (9.5 mm) combination wrench
Converting Broil Burner
CONVERT OVEN BURNERS
This product cannot be converted to Natural gas or LP gas by adjusting or
tightening the oven orifices. The orifices must be replaced.
Tool Needed
1. If installed, remove the oven
racks.
2. Remove the screws from the broil
burner while supporting it, and
remove the broil burner from the
broil orifice holder.
3. Use a 3/8" (9.5 mm) combination
wrench and turn the broil orifice
counterclockwise to remove.
4. Replace the broil orifice with the
correct fuel type orifices. Gas
orifices are stamped with a size
number. Refer to the orifice chart
earlier for correct Natural gas
and LP gas orifice sizes.
5. Place the broil burner gas inlet on
the broil orifice holder and align
the back cutout of the broil
burner with the igniter in the rear
of the oven.
6. Position the broil burner against
the top of the oven and attach it
with the screws removed earlier.
7. Replace the oven racks.
Screws
Broil burner
Orifice holder
Igniter
Orifice
To Next Page
Loading...
Need help?
General
