COTLIN L Series - Booking Ice; Setup Function; Ice-Making Workflow; Check before Start

File No: 1.9.01.00018 Version No:A
Note: Subsequent update versions of this manual will not be noticed.thank you.
service@cotlin.top
10 / 24
11.6 Booking Ice
Standby state (display display "OFF"), first press "[ booking/adding ]" enter time setting, press
"[ booking/adding ]" again can increase 10 minutes, press twice increase 20 minutes, and so on, increase in
10 minutes as a unit, press "[ light/decreasing ]" once can reduce 10 minutes, decline in turn; after setting
up, press "[ switch ]" key, the screen shows the countdown of the s
et time, countdown is 0, the ice machine
began to make ice.
11.7 Setup Function
S
tandby state (screen display OFF), long press "[ clean/set ]" key until screen "OFF" disappear jump into
p
arameter setting state, control addition and subtraction operation by
"
[ reservation/addition ]","[ light/subtract ]", set state light point "[ clean/set ]" switch next setting, parameter
s
witch one round, cycle again from the first parameter."Setting up functions" is recommended for
o
peration under the guidance of a professional and no private adjustment is recommended (see page
1
4 for details);
1
2. Ice-Making Workflow
1
2.1 Power on (power on): after power on the display full light, and then into the power on balance state.
H
ot valve open, water valve, fan control. After 30 seconds press open, after 5 seconds heat valve closed, an
d
s
tart ice.
1
2.2 During the ice making process. The compressor continues to open, the heat valve and drain valve are
c
losed, fan controlled, the pump opened after 30 seconds, the water valve is controlled within 5 minutes of
t
he beginning, and more than 5 minutes forced closure. If the time is more than 23 minutes or the water
t
emperature is less than 3℃, the ice-making time is delayed.
1
2.3 After the ice making is finished, enter the deicing state. The compressor continues to open, the heat
v
alve is open, the water valve is controlled, water pump, fan, and drain valve are closed. The maximum time
l
imit for deicing is 6 minutes. If the ice is not removed for 5 minutes, turn on the pump for 1 minute. If the
i
ce is not removed, turn it into ice. Three times in a row for more than 6 minutes, go to the deicing timeout
s
hutdown.
1
2.4 After the ice is removed, if the ice in the refrigerator is not full, then enter the ice state, a new cycle. If
t
he refrigerator is filled with ice, it will stop. The water pump, compressor, heat valve, upper water valve, fan,
a
nd drain valve are all closed. If the ice is removed, in 180 seconds, the ice full indicator lights shine, and
a
fter 180 seconds of ice, turn to power, for a new cycle. If the ice is not taken away, it is always in full state.
13. Operational Inspections
▲Attention
The ice machine has been tested and debugged in the factor
y
before shipment. In general, new machines do not require an
y
debugging. In order to ensure that the ice-making machine i
s
running normally, it is necessary to carry out the operation inspectio
n.