COTLIN L Series - Leveling Adjustment; Water Supply;Purge; Water Supply; Purge

File No: 1.9.01.00018 Version No:A
Note: Subsequent update versions of this manual will not be noticed.thank you.
service@cotlin.top
7 / 24
Leveling and Adjustment

Screwing home four adjustable parts of the legs first, and then screwing the legs into the ice maker
bottom plate；

Moving the ice maker to the installation place, and adjusting the legs to ensure the ice maker is
leveling.
Water Supply/Purge
7.1 Water Supply

With local potable water quality, determining if a water treatment system is needed to prevent
sediment formation, filter out impurities and remove bleach smell；

Please install the water supply pipe according to the below instruction：

Do not connect the ice maker to the hot water pipe；

The water supply pressure range is 1 bar ～ 5 bar. Using a water pressure regulator for water
supply pressure over rang；

Individual water faucet must be installed for the ice maker.
7.2 Purge

When installing the drain hose, follow these guidelines to be sure all purged water flowing into the
gully drain：

The main gully drain capacity shall be enough for all drain water；

The drain hose should be wrapped with insulation material to prevent condensation；

The drain hose of the water-cool condenser and the drain hose of the ice bin should be placed
separately；

Bout 2.5 centimeters drop is needed for each one meter additional drain hose and must not be
bent.
Good
Bad
Bad
Good
Bad
Bad
7.
6.