COTLIN L Series - Making Ice; Adjustment of Ice Thickness; Enforcement of Deicing; Manual Cleaning

File No: 1.9.01.00018 Version No:A
Note: Subsequent update versions of this manual will not be noticed.thank you.
service@cotlin.top
9 / 24
▲ Attention
The ice machine has been tested and
debugged in the factory before shipment. In
general, new machines can make ice without any
debugging.
Off：The ice making work, press the [switch] key once, the ice making machine stops the ice making
(
standby state), the screen shows "OFF", and then pull out the power plug.
1
1.2
Making
Ice
a
. The ice maker automatically enters the ice making preparation work after electrification, the preparation
p
rocess includes water pump start, hot valve open, compressor start, fan start, etc. Under normal
c
ircumstances, the ice-making machine begins to make ice automatically after the preparation work is
f
inished, and no more operation is required. The ice-making machine stops making ice until the ice is full;
t
he ice-making machine begins to make ice when the ice is taken away；
11.3 Adjustment of Ice Thickness
B. In the ice-making state, press "[ booking/adding ]" or "[ light/decreasing ]" to see the "temperature
display" number on the screen start flashing, press "[ booking/adding ]" can increase 1 minute, press twice
increase 2 minutes, and so on, increase in one unit by 1 minute, press "light/decreas
e ]" once can reduce 1
minute, decline in turn; after adjustment, stop operation," temperature display" number no longer flicker, ice
thickness setting is completed (note: ice thickness adjustment before and after, the ice machine is always in
ice making).
11.4 Forced Deicing
Press the "mode" key to force deicing in the ice-making state；
11.5 Manual Cleaning
Press the "[cleaning/setting]" key in
the standby state, enter the manual cleaning state, cleaning icon flicker,
inlet valve open, screen display start timing, about 15 minutes later, cleaning stop, and start drainage, 30 s
after drainage finished, enter automatic rinsing stage, first wash 3 minutes later, then drain 30 s, rinsing
process recirculates 5 times, the whole cleaning process is finished, screen display "OFF", into standby
state；
Remarks: If you need to clean quickly, you can press "[ Clean/Set ]" again for 15 minutes. After 30 s, you can
finish the drain and enter the rinse stage. If you don't need to cycle many times, you can press [Switch] to
stop the rinse and enter the standby state；