COTLIN L Series - Power Supply; Sanitation after Installation; Check after Installation; Operation

File No: 1.9.01.00018 Version No:A
Note: Subsequent update versions of this manual will not be noticed.thank you.
service@cotlin.top
8 / 24
Power Supply
The voltage, frequency and capacity of the power supply shall be consistent with the nameplate of the
machine；

±10% fluctuation of rated power voltage is allowed；

Separate circuit breakers must be installed for the ice maker.
Sanitation After
I
nstallation

After the ice maker is installed, clean the shell, liner and ice scoop with a clean wet cloth or
sponge；
Check After Inst
allation
After the ice maker is installed, clean the shell, liner and ice scoop with a clean wet cloth or sponge.

Is the ice maker placed levelly？

Have you removed all the transportation seals？

Are all the water and electricity connected well？

Is the supply voltage consistent with the rated voltage on the nameplate？

Is the ice maker properly grounded？

Are there adequate air Spaces around the ice maker？

Is the ambient temperature of the ice maker between 10°C and 38°C？

Does the water inlet temperature remains between 5°C and 32°C？

Are the ice maker and refrigerator cleaned？
Operation
11.1 Turn On/Off
On： Connect the water supply and drainage, plug in the power plug, the screen starts to light up；
8.
10.
11.
9.
 The power supply must be reliably grounded and the wiring used must comply with the laws and
r
egulations of the country and region where the ice maker is used.
 Ice makers must be connected to the potable water pipes.
 Do not put the hard objects under the legs for leveling the ice maker. Make sure the four legs
t
ouch the ground steadily to prevent vibration during operation.
Warning