COTLIN L Series - Critical Parameter; Unpacking; Installation Location

File No: 1.9.01.00018 Version No:A
Note: Subsequent update versions of this manual will not be noticed.thank you.
service@cotlin.top
6 / 24
Critical Parameter
Model Power
(V)
Frequency
(HZ)
Current
(A)
Power
(W)
Refrigerant Liquid
(g/oz)
High side
Design pressure
(psig)
Low side
Design pressure
(psig)
L400 115 60 8.2 880 R290 140/5.0 260 145
L500 115 60 9.8 1030 R290 150/5.3 260 145
is in
with packing list
Unpacking

Before unpacking, check the anti-tilt sign is in good condition, the outer packing of the machine
good condition, and the
machine model is consistent with what you have purchased
；

Take out accessories and affiliated documents, check for its consistency ；

Remove its protective film

If there is any discrepancy or damage, please contact our company/distributor directly
Installation Location

The ice maker is not suitable for outdoor usage, the installation location should not be closed to the
heat source or be exposed to direct sunlight；

The normal working ambient temperature should be ranged between 10°C～38°C, and the water
temperature should be between 5°C～32°C, if the ice making machine operates beyond the above
normal temperature range for a long time, its ice-ma
king capacity may be affected.

Ice makers should be installed on a solid, flat ground；

Ice makers should be placed near a drinkable water supply. It is recommended that the distance
between ice makers be less than one meter.

Do not block the ventilation window of the ice maker. There should be enough air convection space
around the ice maker.

The ice maker can not work at sub-zero temperatures, to prevent supply line failures, empty the ice
maker when the temperature is below zero(see “preparation for long-term storage of ice maker )
3.
4.
5.