Cover Pools Save-T 3 - Cost Considerations

All diagrams are for general information. Consult installation instructions for details.
16
Cost Considerations
Excavation/Plumbing
q Housing excavation
q 3" drain for housing drain— drain to air
or drain to pit
q 3" conduit for hydraulic-unit housing
Electrical
q 1/2" Conduit for mechanism power
q Electric run to key switch
q 15-amp GFCI dedicated circuit for mechanism at
panel (20 AMP for hydraulic)
q Electric runs over 50' require heavy-gauge wire
q Electrical run for accessory board
q 1/2" Conduit (for low voltage wires) required with
Auto-shutoff/CoverLink wired controls
Concrete
q Concrete, gunite or shotcrete box, minimum 6" thick,
3500 PSI, (no rebound)
q Additional deck around housing/mechanism
q Tile on lower beam, beam cover or other
Cover/Mechanism
q Unit price based on track space x pool length
including steps, plus options
q Track space 25' 6" or more may require a larger
main mechanism tube and larger leading edge
for fabric
Track
Underside™ track or Universal track standard
q Track channel for concrete or berglass pools
(2 or 3 sided)
q Flush track
q SnapTop™ track
q Vinyl-liner pool coping 90°, 45°, 6" radius or 24"
radius
q Track channel for vinyl-liner pools
q Vanishing edge 45° or 90°
q Painted track extrusions
Housing
Aluminum lid, bench frame or fiberglass ends standard
q Painted lid extrusions
q Aluminum Lids: Standard, Bezel™ lids, or Flush Mount
q Walk-on Vanishing Lid™ trays
q Bench for deck-mounted mechanism
Power/Controls
110 V motor and hard-wired 3-wire key standard
q Auto-shutoff control with amp limit
q Wireless CoverLink™ digital touchpad control
q Wired CoverLink digital touchpad control
q Water-feature shutoff/accessory board
q Hydraulic pump with hydraulic hoses
q Jandy iAquaLink™ interface & control