3-2 Installation method
3-2-1 Precautions on installation
The water tank capacity of this water purification system is designed for home use.
It is prohibited to install the system for medium/large business or public use.
(If the water purification system is used beyond its capacity, water shortage and/or shortened
filter life may occur as a result.)
Install the product at least 10cm away from the wall and on a firm and level floor.
Installation water pressure
- The feed water supply pressure should be at least 20 psi for the purification system to work
properly, providing enough purified water.
Installation distance from tap water supply
- Feed water pressure 20 psi or higher: Install the system in a place within a range of 3M in height
and 25M in distance.
Do not install the system in a place where it is subjected to direct sunlight, freezing
temperature, and/or excessive moisture.
In the case the system is newly installed or relocated, read the User’s Manual once again
before installation.
This product is for AC 220V/50Hz. Make sure to check the rated voltage before connect the
power cord to the electrical outlet.
Make sure to connect the feed water inlet hose to the cold water piping.
- In the case the feed water inlet hose is connected to warm water piping with the water temperature
of 40°C or higher, filters may be damaged.
Right after the installation, fill up the water tank and drain the water.
Repeat it at least twice before use.
Cleaning the Neo Sense filter 8 inch (S) (for installation and replacement):
Clean the Neo Sense filter 8 inch (S) for about 30 seconds.
Cleaning the Post Carbon block filter 8 inch (S) (for installation and replacement):
Clean the Post Carbon block filter 8 inch (S) for about 3 minutes.
- For initial installation, flush the Post Carbon block filter 8 inch (S) before installing it.
(Flushing the Post Carbon block filter 8 inch (S) during the initial installation minimizes the inflow of
fine particles into the water tank.)
Cleaning the Neo Sense filter and Post Carbon block filter
- Remove the tubing from the bottom of the Neo Sense filter 8 inch (S).
- Connect the Post Carbon block filter 8 inch (S) to the bottom of the Neo Sense filter 8 inch (S).
- Clean the Post Carbon block filter 8 inch (S) with the water coming from the Neo Sense filter
8 inch (S) for about 3 minutes. (Water flow rate 300~500㎖
/min)
- Separate the Post Carbon block filter 8 inch (S) from the Neo Sense filter 8 inch (S) and then
connect it to the bottom of the Membrane filter (RO) 8 inch.
To Next Page
Loading...
