1-2 Precautions on installation
1. Do not install the product where the unit is exposed to direct sunlight or heating devices.
- Otherwise product deformation or fire may occur as a result.
2. Do not install the unit in areas where moisture, water (rainwater) is present.
- Otherwise electric shock or fire may occur as a result.
3. Do not operate the unit in areas where flammable gases or combustible materials are used or stored.
- Otherwise fire may occur as a result.
4. Install the unit on a level area and do not exert excessive force or shock on the unit.
- Otherwise product damage or malfunction may occur as a result.
5. Use tap water as feed water.
6. Do not connect the water inlet to the warm water supply piping.
- Otherwise malfunctions or accidents may occur as a result. (Make sure to connect to cold tap
water suppy piping.)
7.
The length of the water inlet hose must be 5 m or less.
-
If it is longer, it may degrade the product’s performance.
8. The length of the water outlet hose must be 25cm or less.
- If it is longer, it may degrade the product’s performance, and prevent complete drainage of water.
6. Proper places to install the unit
- Install the unit firmly on a level area. If the unit is installed in an unstable place, the system may
not function properly.
To Next Page
Loading...
Need help?
General
