1018028-B Page 14
14-PEK: 14’ PLUG EXTENSION KIT
Units with Terminal Board
1.
2.
3.
4.
5.
6.
heater.
7.
instructions.
8.
9.
10.
11. Snap 90 degree outside corner (Ref. 1) onto 3 foot section (Ref. 2) plastic
12. (Ref. 3) and
remove blue backing and apply to side of heater, butting up against bottom
of other section.
13. Cut 14-inch long bottom section to required length (see chart), insert
14.
15.
BOTTOM SECTION (4)
90 DEGREE
OUTSIDE
CORNER
(1)
3 FT.
SECTION
(2)
3 FT.
SECTION
(3)
FIG. 11
NOTE: Lengths terminate approximately 2 inches above oor.
DVCF55 14 Inches NOTE: Lengths terminate approximately 2 inches above oor.
MODEL NO. LENGTH OF BOTTOM SECTION (Ref. 4) PLASTIC RACEWAY
CAUTION: These kits must be installed by a qualified installer or service technician.
To Next Page
Loading...
