1018028-BPage 9
A.
lighted by hand. When lighting the pilot,
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
WHAT TO DO IF YOU SMELL GAS:
• DO NOT try to light any appliance.
• DO NOT
• DO NOT use any phone in your building.
• Immediately call your gas supplier from
FOR YOUR SAFETY READ BEFORE LIGHTING
MODELS: DVCF403C-H / DVCF404C-H / DVCF553C-H / DVCF554C-H
• If you cannot reach your gas supplier, call
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob
Force or attempted repair may result in a
D. Do not use this appliance if any part has
appliance and to replace any part of the
6. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP!
7. Open sight glass cover.
8. Locate red piezo ignitor button on side of gas control.
tube from gas control).
9.
to
“PILOT”.
LIGHTING INSTRUCTIONS
WARNING:
If you do not
follow these
instructions
exactly, a re
or explosion
may result
causing
property
damage,
personal
injury or loss
of life.
LIGHTING INSTRUCTIONS
TURNING OFF GAS TO APPLIANCE
1. STOP!
2.
3.
4.
5.
to “OFF”.
1.
2.
is to be performed.
3.
4.
to “OFF”. Do not force.
5.
10. Push in pilot control knob and hold in. Immediately
begin a series of pushing and releasing the red
the sight glass. Continue to spark until pilot is lit.
Continue to hold the pilot control knob in for about
remain lit. If pilot goes out, repeat steps 4 thru 9.
- If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
- If the pilot will not stay lit after several tries, turn the gas
control knob to “OFF” and call your service technician
or gas supplier.
11. Close sight glass cover.
12.
to “ON.”
13.
14. Turn on all electric to the appliance.
15. Set thermostat to desired setting.
NOTE:
Knob cannot
be turned from
“PILOT” to “OFF”
unless knob is
pushed in slightly.
Do not force.
Gas Control Knob
Pilot Control Knob
To Next Page
Loading...
