Cradlepoint CBR400 - Page 79

CRADLEPOINT CBR400| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 77
Ethernet Port Configuration
Ethernet Port Configuration provides
controls for your router‘s Ethernet port. You
have the ability to control: Mode (WAN or
LAN) and Link Speed. Additional controls
for WAN ports are available in Internet →
Ethernet Settings.
Mode: WAN or LAN. Default setting is LAN
(Local Area Network).
 Internet (WAN) is used to connect to another network such as a hotel or office wired network. The WAN
connection is used as a possible source of internet for the CBR400.
 Local Network (LAN) is for connecting a computer or similar device directly to the router with an Ethernet cable.
NOTE: When a port group uses the LAN mode you must separately ensure that this logical interface is attached to a Local IP Network in the top
panel of this page.
Link Speed: Default setting is Auto. The Auto setting is preferred in most cases.
 Auto
 10Mbps - Half Duplex
 10Mbps - Full Duplex
 100Mbps - Half Duplex
 100Mbps - Full Duplex
 1000Mbps - Full Duplex