applicable charges regardless of whether the router uses a wired or wireless Internet connect. To avoid
such data usage and potential charges, refer to
Router Communication/Data Usage for more information.
Required Tools for Setup
Cradlepoint recommends that a professional install the R1900 in any environment. However, the
following tools may be necessary for setup.
• #0 Philips-head screwdriver (for SIM cover screws)
• #2 Philips-head screwdriver (for mounting screws)
• Mounting tools - Depending on the location of installation, additional mounting tools may be
necessary. These tools may include, but are not limited to:
o Screwdrivers
o Drill and drill bits
o Additional screws
o Zip ties
Setup
Refer to the following for general setup instructions.
STEP 1: Check box for contents.
Prior to having the R1900 router installed, open the box and ensure that all items are present. You
should have received the following:
• [1] R1900 series router
• [1] 3-meter (2x2) Power and GPIO cable
• [4] M4 screws, nuts, and washers
• [1] Mounting template
• [1] Quick Start Reference sheet
• [1] Safety, Warranty, and Regulatory guide
Accessories
To optimize the R1900 series router for Wireless WAN or with failover configuration, you will need at
least one activated 4FF-sized SIM card, with an active cellular data plan.
Additional accessories to enhance your router capabilities include, but are not limited to:
• OBDII cable
• RX30-POE
• Antennas
o Refer to the
Cradlepoint Antenna webpage for assistance in locating a Cradlepoint
Approved vendor.
STEP 2: Remove the SIM door.
To Next Page
Loading...
Need help?
General
