10
STEP ONE (continued)
2. Turn the stand top upside down. Insert the eye
screw (#213) in the slot on the underside of the
stand top using 1 1/4” bolt (#215) and nut (#214).
Tighten but ensure that it can still move freely (it
should be able to hold its position but still pivot).
3. Slot the motor plate into the stand and bolt in with
3/4” bolts (#217) and nuts (#214). Nuts should be
snug but not tight.
4. Slip the eye screw through the hole in the motor plate; slip on washer (#221).
Attach the motor knob (#210) to the end of the eye screw.
To Next Page
