14
STEP THREE (continued)
4. Measure the distance from each corner on
the base of the saw body to the edge of
saw stand table to square up. Once this is
done, securely tighten all four bolts (you
will need to get on the floor and
underneath the table to do this).
5. Pull the motor’s power cord through the
hole in the stand and attach it to the stand
using a bolt (#222) and a washer (#225)
above and a washer (#225) and a nut
(#224) below on each side of the cord.
Plug in the cord from the saw.
To Next Page
