6
CX213 &CX214 Cabinet Saw
Thank you for Choosing the CX213 or
CX214 for your Cabinet Saw. This unit
has been tested and inspected before
shipment to insure optimum
performance and trouble free operation.
NOTE:
Reasonable amount of care and
attention is required when setting up this
machine in your shop. You may need to
fine tune your machine for optimum
performance.
In order to get the most out of your new
cabinet saw you will need to go over this
manual thoroughly before assembling
and installing this machine for operation.
The CX213 & CX214 cabinet saw
features a circular blade underneath that
may be raised and lowered to control
the overall depth of cut. This cabinet
saw is also equipped with a rail mounted
fence that slides effortlessly towards or
away from the saw blade. The fence is
your main cutting guide for your work
piece.
The supplied miter gauge is used to
support and guide your work piece
during cutting operations when the work
piece cannot slide against the fence in a
stable manner. The miter gauge body
can be rotated to allow for cutting a wide
range of angles.
The blade guard assembly on the
CX213 & CX214 is equipped with
spreader anti kickback paws and riving
knife that help to prevent kickback
and/or stop and slow kickback when it
occurs.
To Next Page
Loading...
Need help?
General
