Crate LIMO TX50D User Manual

©2001 SLM Electronics • A division of St. Louis Music
1400 Ferguson Avenue • St. Louis, MO 63133
P/N 47-099-02 • 08/01
CRATE
TECHNICAL SPECIFICATIONS
OUTPUT POWER RATING 50W RMS @ 10% THD, 4 ohms, 13.6VDC in
INPUT IMPEDANCE 1M ohm
MAXIMUM SIGNAL ACCEPTED
Mic Low Z 2V peak to peak
Mic Hi Z 12V peak to peak
Instrument 12V peak to peak
GAIN Mic 57dB High Z, 72dB Low Z
Instrument 44dB w/Gain switch out, Ch2
85dB w/Gain switch in, Ch1
SENSITIVITY Mic 3.5mV RMS High Z, 20mV RMS Low Z
Instrument 80mV RMS w/Gain switch out, Ch2
.8mV RMS w/Gain switch in, Ch1
Line In Insert 400mV RMS
EQS, MIC Low ±15dB @ 60Hz
Mid ±15dB @ 600Hz
High ±15dB @ 10kHz
EQS, INSTRUMENT Low 12.5dB range @ 80Hz
Mid 18dB range @ 800Hz
High 18dB range @ 10kHz
Shape Crate proprietary circuit
INSERT JACK Tip Line In
Ring Line Out
Sleeve Ground
SPEAKERS Woofer Crate Custom Design 10”, 4 ohm, 100 watt
1.5” voice coil, 16 oz magnet
Tweeter 2” Piezo , 4 ohm, 150 watt network
POWER REQUIREMENTS Internal 12 volt DC power supply
DC adapter for use with 120VAC
Optional 12V vehicle lighter adapter
SIZE AND WEIGHT 18-1/2”W x 13-1/2”H x 12-1/2”D; 22 lbs.
The TX50DE is enclosed in a rugged, molded high tech polymer cabinet. Wipe
the enclosure with a damp, lint-free cloth to remove dirt and road film. Never
spray cleaning agents directly onto the enclosure, and stay away from abra-
sive cleansers which could damage the finish.
Crate continually develops new products, as well as improves existing ones. For this reason,
the specifications and information in this manual are subject to change without notice.
www.crateamps.com

Crate LIMO TX50D Specifications

Power

output power rating	50W RMS @ 10% THD, 4 ohms, 13.6VDC in
power requirements	Internal 12 volt DC power supply
DC adapter	for use with 120VAC

Input and Output

input impedance	1M ohm
maximum signal accepted - Mic Low Z	2V peak to peak
maximum signal accepted - Mic Hi Z	12V peak to peak

Gain and Sensitivity

gain - Mic	57dB High Z, 72dB Low Z
gain - Instrument	44dB w/Gain switch out, Ch2, 85dB w/Gain switch in, Ch1

EQ Settings

EQS MIC Low	±15dB @ 60Hz
EQS MIC Mid	±15dB @ 600Hz
EQS MIC High	±15dB @ 10kHz

Size and Weight

width	15-1/2”
height	13”
depth	12”